Simply press and hold the power button until the LED indicators illuminate sequentially in red, blue, and green, followed by a blinking pattern. Upon activation and upon establishing connections to both cellular and GPS satellite networks, the device's LED indicators will begin blinking in the sequence of red, blue, and green.
Upon successful connection, the LED indicators will cease to illuminate. However, in the event that the device fails to establish a connection to either the cellular or GPS network, the LED indicators will continue to blink.
After a successful connection, the device will commence updating on the Family1st platform. Should updating fail to occur, it is recommended to relocate the device to an area with better signal reception, such as near a window or outdoors, or alternatively, to embark on a 10-minute drive to improve signal strength.
To power off the device, initiate a long press on the power button until the LED indicators illuminate in the OFF pattern, denoted by the sequential illumination of all three colors followed by the deactivation of green, blue, and red. Continue holding the power button until all LEDs have been extinguished.
To confirm that the device is completely powered off, press the Reset button and observe the absence of any blinking LEDs. At this point, the device can be considered turned off.
If you have any questions, contact Family1st support at support.gps@family1st.io or 855-462-7819 (M-F: 9AM - 5PM PDT) for assistance.
Was this article helpful?
👍 👎0 liked this article
0 disliked this article
Still need help? Message Us
